Teejet Matrix Pro 840GS User Manual download pdf (Page 64)

www.teejet.com

HOMEOVERVIEW SETUP IMPLEMENT FULL SCREEN GPSINTRODUCTION GUIDANCE DROPLET MONITOR

SINGLE SECTION SETUP

Single section setup is used when a Smartcable or Section Driver

Module (SDM) is not on the system. The entire boom or delivery

area is considered to be one section.

NOTE: If a Smartcable or Section Driver Module (SDM) is

present, refer to "Smartcable or Section Driver Module

setup" to view setup steps.

1. Press CONFIGURATION side tab .

2. Press

implement .

3. Select from:

►Machine type – used to select the type of machine that

most closely represents your machine.

►GPS antenna height – used to measure the height of the

antenna from the ground. Range is 0.0 to 10.0 metres.

►Implement type – used to select the layout of the sections

for the applied product location.

►Implement offset distance  – used to enter the distance

from the centreline of the machine to the centre of the

implement. Range is 0 to 10.0 metres.

NOTE: For detailed setup instructions, refer to the

Implement Offset section of this chapter.

►Implement offset direction  – direction from the centreline

of the machine to the centre of the implement while facing

in the machine's forward direction

►Guidance width – used to enter the distance between the

guidelines. Range is 1.0 to 75.0 metres.

►Application width [straight implement type] – used to enter

the total width of the implement.

►Working width [spreader implement type] – used to enter

the total width of the implement.

►Applied area alarm – used to establish an alert to signal

when exiting or entering an applied area

►Applied alert exit time – when applied area Alarm is

enabled, used to set the amount of time before exiting an

applied area at which the alarm will sound. Range is 0 to

10 seconds.

►Applied alert entry time – when applied area Alarm is

enabled, used to set the amount of time before entering an

applied area at which the alarm will sound. Range is 0 to

10 seconds.

4. Press NEXT PAGE arrow to set up the selected specic

implement type's options.

Figure 8-8: Implement – single section

Figure 8-9: Implement offset distance and direction

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 81 82

Comments to this Manuals

No comments

Teejet Matrix Pro 840GS User Manual Page 64

Comments to this Manuals

Related products and manuals for Computers Teejet Matrix Pro 840GS