Teejet Matrix Pro 840GS User Manual download pdf (Page 19)

98-05273-EN R4

HOME OVERVIEWSETUP IMPLEMENT FULL SCREENGPS INTRODUCTIONGUIDANCEDROPLET MONITOR

Implement

Implement setup is used to establish the various settings

associated with straight mode, spreader mode or staggered mode.

For detailed setup instructions, refer to the Implement chapter in

this manual.

Settings will vary depending on if a SmartCable or Section Driver

Module (SDM) is present.

Implement type

Implement type selects the type of application pattern that most

closely represents your system.

● In Straight mode – the boom sections have no length and

are on a line a xed distance from antenna

● In Spreader mode – a virtual line is created in line with the

delivery disks from which the application section or sections

can vary in length and can be at different distances from the

line

● In Staggered mode – a virtual line is created in line with

Section 1 from which the application section or sections

have no length and can be at different distances from

antenna

Figure 5-4: Implement type - Straight

Figure 5-5: Implement type - Spreader

Figure 5-6: Implement type - Staggered

Single section setup

Single section setup is used when a SmartCable or Section Driver

Module (SDM) is not on the system. The entire boom or delivery

area is considered to be one section.

NOTE: If a SmartCable or Section Driver Module (SDM) is

present, refer to "SmartCable or Section Driver Module

setup" to view setup steps.

1. Press CONFIGURATION side tab .

2. Press Implement .

3. Select from:

►Machine type – used to select the type of machine that

most closely represents your machine.

►GPS antenna height – used to measure the height of the

antenna from the ground

►Implement type – used to select the layout of the sections

for the applied product location.

►Implement offset distance – used to enter the distance from

the centreline of the machine to the centre of the implement

►Implement offset direction – direction from the centreline of

the machine to the centre of the implement while facing in

the machine's forward direction

►Guidance width – used to enter the distance between the

guidelines

►Application width [Straight implement type] – used to enter

the total width of the implement

►Working width [Spreader implement type] – used to enter

the total width of the implement

►Applied area alarm – used to establish an alert to signal

when exiting or entering an applied area

4. Press NEXT PAGE arrow to set up the selected specic

implement type's options.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 81 82

Comments to this Manuals

No comments

Teejet Matrix Pro 840GS User Manual Page 19

Comments to this Manuals

Related products and manuals for Computers Teejet Matrix Pro 840GS