Teejet Sentry 6140 User Manual download pdf (Page 9)

98-05306-ENUS R2

Sentry 6140 Tip Flow Monitor

Flow Meter Assembly

The ow meter gasket has two different sides. The side with the larger

center is to be inserted towards the sensor or inside the ow meter.

Figure 5: Flow Meter and Gasket

Flow Meter

Gasket

Figure 6: Gasket Detail

Towards

ow meter

Kit Assembly

1. Remove end cap from nozzle body.

2. Attach end cap to ow meter (J).

3. Attach ow meter to nozzle body. Hand tighten.

4. Loosely secure Tip Sensor Interface (H or I) close to nozzle body

/ ow meter assembly. Cable ties (not included) can be threaded

through Tip Sensor Interface slots.

5. Push sensor of Tip Sensor Interface into slot on owmeter. Clips on

ow meter should be in the groves on the center of the sensor.

6. Secure Tip Sensor Interface.

7. Connect Start Terminator (L) to section 1 Tip Sensor Interface.

8. Connect each Tip Sensor Interface moving from left to right (while

standing at the back of the machine).

►Extension cables from Boom Interface Module Harness (E) and

Tip Flow Monitor Interface Harness (C) will connect between

two Tip Sensor Interfaces.

9. Connect End Terminator (K) to the last section’s Tip Sensor

Interface.

Figure 7: Nozzle Body with Flow Meter Assembly

Flow Meter

Nozzle Body

End Cap

Figure 8: Sensor & Clips

Sensor

Clips

Figure 9: Tip Sensor Interface Slots

Tip Sensor Interface slots

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Teejet Sentry 6140 User Manual Page 9