Teejet CenterLine 2.0 User Manual download pdf (Page 46)

40 CenterLine

CenterLine Real-Time Operation

CenterLine

Software Version 2.00

Return to Point

CenterLine allows the operator to mark a point in the field to return to later in time. Typi-

cally the Return to Point feature is used to mark a location when stopping guidance and

wanting to start in the same location and in the same direction at a later time. This Return

to Point location is stored with the field’s trajectory data, is lost when <NEW?> is selected,

and retained when <RESUME?> is selected.

There is a specific Return to Point key located on the wireless remote, see Figure 4. This key

works in toggle fashion; press it once to mark the point (the lightbar displays <ÎÍ>), press it

again to navigate back to the point. Stop the navigation process by pressing ESC. When Return

to Point is pressed again (third time) the old location is replaced with the current vehicle location.

While operating in the Return to Point mode, no active text messages are displayed except error

messages. If the vehicle enters an area that has already been applied, the display alternates

between the Return To Point distance and <Applied!>.

Exiting Real-time Operation

To exit guidance, press Esc or scroll with Up or Down in the real-time menu until <EXIT?> is dis-

played (Figure 45) in the text window and Press Enter. <BYE> appears in the text window, real-

time operation stops, and the display returns to the main menu.

Figure 45: Exit in Display

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 65 66

No comments

Teejet CenterLine 2.0 User Manual Page 46