Teejet LH 1200S User Manual download pdf (Page 24)

LH 1200S O

PERATORS MANUAL

24 LH A

GRO

Procedure

1. Prepare the implement for calibration. Do not turn the metering shaft after the

monitor has been prepared for calibration.

2. Encode a flow figure of 9999:

Press the keys in this order and the monitor is ready for counting pulses.

3. Reset the litre counter as follows:

Press

Press the L key then press and hold thereafter the 0/C key until the litre

counter is zeroed.

4. Calibrate the implement as described in the manual for the implement and

weigh the amount released precisely.

5. The calibration figure for the machine can be calculated as follows:

Amount released in grams x 100

NEW CALIBRATION FIGURE

(FLOW FIGURE) =

Pulses displayed on the monitor

Encode the calculated values as the new flow figure.

NOTE! The calibration figure can be changed by using the +/-% key if the

percentile deviation of the volume monitoring is known. Each time the

key is pressed the sign is changed. It is only possible to adjust the

calibration figure by whole % values.

Procedure:

If the monitor has counted too much, a negative correction must be made.

The following example assumes that the monitor has counted 3% more than the

actual amount sown/spread. This can be corrected as follows:

Press

Pressing the keys in the shown order will alter the calibration figure (flow figure) by

–3%.

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

Teejet LH 1200S User Manual Page 24