Teejet LH 1200S User Manual download pdf (Page 19)

LH 1200S O

PERATORS MANUAL

LH A

GRO 19

MANUAL SPEED CALIBRATION

1. Mark the field and the tyre.

2. Drive forward until the wheel has turned 10 times.

3. Mark the field again.

4. Measure the distance between the two marks and divide by 10. The result is

the effective wheel circumference.

5. Divide the effective wheel circumference by the number of magnets fitted.

Encode the result in centimetres with 1 decimal, 2.535 m is encoded as 253.5

cm. the maximum value that can be encoded is 300.0 cm.

NOTE! Remember to count wheel revolutions on the wheel that the magnets are

fitted.

WORKING WIDTH AND BOOM SECTIONS

Key Function

WORKING WIDTH

This encodement value is divided into main encodement values – the total

working width – and some sub-encodements – quantity correction yes/no,

when the individual boom sections (the width of) are turned off.

Procedure:

As all of these encodements are placed under the same key, the program has

been constructed so that you can page through the encodements by repeatedly

pressing the working width key. The total working width can be encoded after a

short press on the key. It is not necessary to encode further if you are not working

with boom sections.

If you want to work with boom sections pressing the key again for min. 5 seconds

will allow you to encode the boom section width.

1. ENCODING THE WORKING WIDTH

Press the keys in this order. XXXX

states the actual working width in

centimetres. (4 metres = 400

centimetres)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Teejet LH 1200S User Manual Page 19