Teejet FieldPilot Install Ford Versatile 8x6-9x6 User Manual download pdf (Page 3)

www.teejet.com

FieldPilot

PREPARATION

1. Before beginning the installation, thoroughly clean the vehicle to remove dirt and contaminants that might

get into the hydraulic circuit.

2. Park the vehicle on a clean, level oor with adequate clearance to work around.

3. Do not attempt to loosen any hydraulic ttings while the engine is running.

4. Allow the motor and the hydraulics to cool until it is no more than warm to the touch before proceeding.

5. Prior to loosening any hydraulic ttings, be sure to have the appropriate plugs and caps available in order

to limit loss of hydraulic uid from the open ttings.

PREVENT HYDRAULIC SYSTEM CONTAMINATION. It is essential to thoroughly clean hydraulic

system ttings and hose connections prior to disconnecting or removing them. Use a spray

cleaner such as “Brake Clean” to prevent hydraulic system contamination. Note that o-rings used

on ORB and ORFF type ttings may be damaged by solvent cleaners such as “Brake Clean”. If a tting is to

be cleaned internally, the o-ring should rst be removed and cleaned with a berless cloth.

IMPORTANT

TO AVOID EXCESS LEAKAGE, DO NOT TURN THE STEERING WHEEL WHILE

THE FITTINGS ON THE MANUAL STEERING VALVE ARE DISCONNECTED.

WARNING: HOT, HIGH PRESSURE FLUID HAZARD. Hydraulic oil may be hot and under

extreme pressure. To prevent serious injury or death, relieve system pressure and allow the

system to cool before repairing or disconnecting. Wear proper hand and eye protection when

searching for leaks, using wood or cardboard instead of hands. Keep all hydraulic components in good

repair.

WARNING: PINCH POINT HAZARD! To prevent serious injury or death, avoid unsafe practice

while manually operating hydraulic steering circuits. Keep others away and stay clear of

mechanical steering linkages.

1 2 3 4 5 6 7 8 ... 19 20

No comments

Teejet FieldPilot Install Ford Versatile 8x6-9x6 User Manual Page 3