Teejet Matrix Pro 840G BoomPilot Setup User Manual download pdf (Page 9)

98-05243-ENUS R2

Matrix

Pro

Implement

Implement Setup is used to establish the various settings associated

with the vehicle’s implement.

Settings will vary depending on if a SmartCable or Section Driver

Module (SDM) is present.

Speed Out / Sense In cable

This cable is REQUIRED to start application mapping (painting the

screen).

It allows the user to operate the area applied function of the Matrix

Pro in series with a remote master connection or existing apply on/off

toggle in a single swath manner. However if the previous connections

are not available the supplied toggle switch allows area applied

functionality without the need to connect to a functional application

implement.

The cable also sends a radar speed signal to an external device.

To install your cable:

• Connect using included switch (32-50008)

• Connect green wire to master 12 Volts on/off from rate controller

Figure 1-15: Speed Out / Sense In cable

Speed Cable

45-05615

Speed/

Status

+12v

Connect Green

Wire

Connect Red Wire

OFF

Green Wire

Sense

Red Wire (+12v)

32-50008

Switch, Master

Radar

Speed Out

45-05765 8 Pos.

Speed/Sense Cable

Matrix Pro 570G

Matrix Pro 840G

Implement – Single Section Setup

Implement for a single boom is used to establish guidance width and

spray width.

NOTE: If a SmartCable or Section Driver Module (SDM) is present,

refer to “SmartCable or Section Driver Module Setup” to view

setup steps.

1. Press CONFIGURATION side tab .

2. Press Implement .

3. Select from:

►Guidance Width – used to enter the width between the

guidelines

►Spray Width – used to enter the width of the implement

4. Press RETURN arrow or CONFIGURATION side tab to

return to the main Conguration screen.

Figure 1-16: Implement Setup Options with No SDM

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong->Implement

Num Sections

Spray Width

Guidance Width

60.00 ft

12.00 ft

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Teejet Matrix Pro 840G BoomPilot Setup User Manual Page 9

Comments to this Manuals

Related products and manuals for Computers Teejet Matrix Pro 840G BoomPilot Setup