Teejet Matrix Pro 840G BoomPilot Setup User Manual download pdf (Page 11)

98-05243-ENUS R2

Matrix

Pro

Implement – SmartCable or Section Driver Module Setup

Implement is used to establish number of boom sections, guidance

width, spray width, overlap percentage, implement delay on time and

implement delay off time.

NOTE: If a SmartCable or Section Driver Module (SDM) is not present,

refer to “Single Section Setup” to view setup steps.

1. Press CONFIGURATION side tab .

2. Press Implement .

3. Select from:

►Number of Boom Sections

– used to select the number of

available boom sections

►Guidance Width – used to enter the width between the

guidelines

►Spray Width – used to enter the width of each implement

section

►Overlap – used to select the amount of overlap allowed

when the boom sections are turned on and off

►Delay On – used to enter the timing for the boom section

valves to switch on

►Delay Off – used to enter the timing for the boom section

valves to switch off

4. Press RETURN arrow or CONFIGURATION side tab to

return to the main Conguration screen.

NOTE: Press or to switch between Implement setup screens.

NOTE: Implement settings are only visible and necessary if a

SmartCable or SDM is installed. If neither is present, see

Single Boom Setup section.

Figure 1-19: Implement Setup Options with SmartCable or SDM

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong->Implement

Num Sections

Spray Width

Guidance Width

60.00 ft

12.00 ft

Cong->Implement (2)

Overlap

Delay O

Delay On

1.00 s

50%

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Teejet Matrix Pro 840G BoomPilot Setup User Manual Page 11

Comments to this Manuals

Related products and manuals for Computers Teejet Matrix Pro 840G BoomPilot Setup