Teejet SmartPad II Lightshow User Guide User Manual download pdf (Page 7)

Page 7 of 11

Definition: Displays the heading error not determined message. This is the message presented to the

user during guidance if Heading Error was selected in setup as a display message and the vehicle

heading has not yet been determined.

Example: "heading_na" - displays ??? in the lightbar screen.

Keyword: xtrack

[OptParam1] The cross-track error (negative for left arrows).

[OptParam2] None

Definition: Displays the cross-track error message. This is the message presented to the user during

guidance if X-Track was selected in setup as a display message.

Example: "xtrack -2.3" - displays 2.3 with left arrows on either side in the lightbar screen.

Keyword: brightness

[OptParam1] Sets the LED brightness (1-100).

[OptParam2] Sets the Text display brightness (1-100).

Definition: Sets the lightbar LED and text display brightness.

Example: "brightness 50 70" - sets the LED brightness to 50% and the text display brightness to

70%.

Keyword: flash_on

[OptParam1] None

[OptParam2] None

Definition: Enables flashing lights (such as the guidance lights) on the lightbar. Note that this is the

default state when Light Show starts.

Example: "flash_on" - enables flashing lights.

Keyword: flash_off

[OptParam1] None

[OptParam2] None

Definition: Disables flashing lights (such as the guidance lights) on the lightbar. If these lights are tuned

on, they will not flash.

Example: "flash_off" - disables flashing lights.

Figure 11: xtrack

1 2 3 4 5 6 7 8 9 10 11

No comments

Teejet SmartPad II Lightshow User Guide User Manual Page 7