Teejet IC18 NH3 JOB COMPUTER User Manual download pdf (Page 30)

www.teejet.com

ISOBUS Job Computer : IC18 NH3

OVERVIEW SETUP APPENDIXGETTING STARTED OPERATION

Filling

Filling establishes the amount of material remaining in the tank and the density of that material.

NOTE: The size of the tank is established in the OEM menu. This is the number that will repopulate when the Full

Tank Key is pressed.

Figure 3-14: Filling

Actual Content

Actual Content displays the current volume of content in

the tank. The volume can be manually adjusted.

• To adjust thevolume, use the number pad or slide

bar.

Density Factor

Density Factor establishes the weight per volume setting

based on the type of fertilizer being used.

• To select the Density Factor, use the number pad or

slide bar.

The fertilizer’s ability to ow is affected by a number of

factors. These factors may vary with each batch and it

may change due to weather (humidity, etc.). In order to accommodate for this, the job computer uses a density

factor to compensate for the nature of the applied fertilizer.

Full Tank

Full Tank returns the Actual Content volume value to the maximum volume of the tank

• To reset the Actual Content value, press the FULL TANK KEY .

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

No comments

Teejet IC18 NH3 JOB COMPUTER User Manual Page 30