Teejet LH 1200S User Manual download pdf (Page 3)

LH AGRO 3

HOW TO MOUNT THE 1200 S

Monitor: Place the unit in the cabine. Check location of the junction box and

ensure right cable length.

Junction box: Place the unit in the cabine (Note: two versions! - with or without

switches. Only junction boxes with switches can be connected to a

PTO/RPM sensor).

Pull away plug: Mount on the near side of the tractor (see diagram).

Speed transmit: Mount on the right rear wheel (see diagram). If you wish to

measure, using a 4 WD drive shaft you must use a special sensor.

A description of these follow.

Override sensor: Mount on the tractors lift arms (see diagram).

Power: Always connect through the ignition switch

PTO/RPM: (Extra) Sensor to measure revolutions (PTO-motors etc.). The

sensor set including a magnet ring for axels need to be ordered

separatly.

CONNECTIONS IN THE JUNCTION BOX

FOLLOW THE COLOUR CODES ON THE CIRCUIT BOARD AN CABLES

Attach all cables to the

circuit board using the

supplied straps.

1 2 3 4 5 6 7 8

No comments

Teejet LH 1200S User Manual Page 3